Shelly 1 relay

Mine is pretty much transparent. Lights have Shelly 1 configured as a "edge" so the old light switch toggles it's state. I have my hot water cylinder controlled but in parallel to the original thermostat and timer. My original garage door openers still works from the rf remotes but you can use hass, and get notified when it's opened or left open. Mostly The rest of my system is home security, I had a cheap Chinese alarm system with a bunch of 433mhz sensors, it wasn't convenient or easy to use and required a sim card to send messages when triggered so I ditched that and did it from hass with …

Excerpt saved from the Arctic Shift Reddit archive on 2026-10-23.

New 1. Installed WS2812b LED strips on house in aluminum channels for permanent holiday lights. 2. Installed Shelly1 to control my garage lights. 3. Setup Node-red and created my first flow to turn on garage lights when garage door is opened. Fixes 1. Lost ecobee sync due to file system error. Just had to go into integrations and delete the ecobee listing then readd. TODO 1. Setup WYZE sense to use in home assistant. 2. Setup security system routines in Node-red using WYZE sense. 3. Setup WYZE camera in home assistant.

Excerpt saved from the Arctic Shift Reddit archive on 2026-10-23.

… in the rest of the world is not UL. I've never seen anything at a major brick and mortar retailer in Canada which isn't. All of my switches are either Shelly 1, Shelly 2.5 or Lutron Caseta, all of which are cULus listed. Obviously stuff like my Aqara ZigBee sensors aren't, but they're not connected to mains.

Excerpt saved from the Arctic Shift Reddit archive on 2026-10-23.

Almost all garage door openers have a terminal strip where bridging two terminals causes the door to open or close. Add a Shelly 1 or any smart relay and job done.

Excerpt saved from the Arctic Shift Reddit archive on 2026-10-23.