GoControl
GoControl GD00Z-4 Garage Door Opener
Garage Door Openers · Security
Works
1 report: 1 says it works.
Reported with 1 Homebridge plugin: Alarm.com.
What people report
| Plugin | Status | What they said | Connects | Source |
|---|---|---|---|---|
Alarm.comnode-alarm-dot-com | Works | Garage door support added and tested with this openerSaved copy@mkormendy I'm pretty sure they aren't a result of a sensor block. I have a "dumb" garage door opener. The GoControl essentially functions as an Z-wave relay. The safety sensors in my setup have no way of communicating to the opener motor, GoControl relay, or alarm panel. There is a small tilt sensor on the door itself that reports open/close state to the relay and then back to the panel. There are two possible failures: 1) communication failure where the panel fails to reach the z-wave component with the state change command or 2) the sensor is blocked. Technically a 3rd would be the tilt … Excerpt saved from GitHub on 2026-10-22. | Cloud | PR #9 · 2020-07 |
Each row is one report from a plugin’s GitHub issues, pull requests, discussions, wiki or docs, or from r/homebridge. Check the date and the linked thread before you buy.
In ReReHome
Once a Homebridge plugin publishes it, this device reaches Apple Home as a HomeKit accessory behind your Homebridge bridge, so ReReHome shows and controls it like any other.
Identifiers
| Brand | GoControl |
|---|---|
| Model | GD00Z-4 |
| Category | Garage Door Openers |
Also reported as
- GoControl/Linear GD00Z-4 Z-Wave garage door opener
